| 1. | Similar cyclic stresses may have occurred due to wind-induced swaying motion during storage .
同样在存放时由风力引起的横向摆动也可以产生类似的循环应力。 |
| 2. | Cyclic stress energy dissipation
周期应力能量耗散 |
| 3. | Schoolbags . test methods . determination of the mechanical loaded cyclic stress
书包.试验方法.周期加载机械应力的测定 |
| 4. | Maximum cyclic stress
最大循环应力 |
| 5. | Leathers and hides . determination of the resistance of leathers to repeated bending with of without cyclic stresses . crossed folds method
皮革.有和无循环应力作用下皮革耐反复弯曲的测定.交叉褶皱法 |
| 6. | Both tests and calculations were performed to get the fatigue lives for six kinds of multidirectional laminate coupons with different tensile cyclic stress applied
进行了带孔层压板在拉?压疲劳载荷下的疲劳模拟，预测结果与有关文献提供的实测结果符合良好。 |
| 7. | The relationship between the cyclic stress response of tension and torsion and the cycle number were measured and studied subjected to proportional and non - proportional loadings
分别测试和研究比例与非比例拉扭加载下拉与扭的应力响应值随循环数的变化关系。 |
| 8. | The first stage is primary slip then followed by secondary slip ; the last stage is due to dislocation passing the slips . the cyclic stress strain ( css ) curve exhibits a stronger hardening occurred in cyclic plastic deformation than that in tensile test
建立了拉伸和应变疲劳的有限元模型，使用基于晶体滑移模型的数值方法，对晶体内部滑移系的启动以及滑移系上的分解切应变、切应力这些无法试验观测的变量进行计算，分析它们对晶体塑性变形的不同影响。 |
| 9. | The approximate polynomial method was based on neuber ' s method , the cyclic stress - strain responses and neuber ' s rule were treated as probabilistic curves , and the statistic characteristic was obtained from the approximate polynomial . the method is fast and easy for engineering application
近似的多项式拟合法在诺伯法的基础上，将循环应力应变曲线和诺伯双曲线视为概率曲线，通过建立近似多项式的方法，求得局部应力应变的统计特性，快速简便，适合工程应用。 |
| 10. | The alloys , which were cold - worked followed by recrystallization annealing , display cyclic softening in the range of low strain because the cyclic stress - strain curve lies below the monotonic stress - strain curve , and show cyclic hardening in the range of high strain because the cyclic stress - strain curve lies above the monotonic stress - strain curve
在低应变范围，冷加工后经再结晶退火处理的错合金的循环应力一应变曲线位于单调拉伸曲线的下方，表现为循环软化;在高应变范围则位于单调拉伸曲线的上方，表现为循环硬化。 |
